In case you are smelling a pungent smell coming from your dishwasher or you are seeing some food particles on the dishes after cleaning them, it often is an indication that it is time to clean your filter.
Cleaning your dishwasher might often seem like an extremely daunting job but what if we told you it is not?
Cleaning the filter of a dishwasher merely takes a few minutes and only involves water and soap. Here is how you can clean the filter of your dishwasher.
Here are 2 Methods and Steps to Clean A Dishwasher Filter:
Table of Contents
Method 1 Step 1: Removing The Dishwasher Filter
Move the bottom rack out of the dishwasher to uncover the filter. Open your dishwasher and pull the bottom dish rack out to uncover the rear of the machine. You will see three things: a spray arm, a cylindrical filter, and a coarse mesh filter.
The cylindrical and coarse mesh filters are the parts of the dishwasher you will have to clean.
Assuming the bottom rack is in your way, you can remove it from the dishwasher. Also, make sure to take out any dishes that might be on the rack before you do so.
Step 2:
Turn the cylindrical filter counter-clockwise and lift it straight up. Move the spray arm so you can pull the cylindrical filter straight up without hitting your hand on the arm.
Then, at that point, turn the cylindrical filter strongly to the left and get it out of the dishwasher.
Assuming there is gunk developed on the filter, you will have to clean it thoroughly.
Step 3:
Slide the coarse filter out of its place in the dishwasher. It is a flat, U-shaped filter with an opening in it where the cylindrical filter goes. Slide it out of the dishwasher and check if there is a buildup on its surface.
Whenever you have taken out both filters, place your hand in the opening where the cylindrical filter sits. That is known as the “sump”, and it could contain food particles or other gunk.
Assuming you feel there is anything in that hole, remove it right away and throw it.
And now, put everything in its place. With that, your dishwasher’s filter is finally clean.
Method 2 Step 1: Cleaning and Reinstalling the Dishwasher Filter
![dishwasher not cleaning](https://dishwasherusa.com/wp-content/uploads/2020/08/DIY-Dishwasher-Troubleshooting-Tips-and-Tricks-August-2020.jpg)
Turn on the faucet to get a stream of hot water. Leave the faucet running until the water is hot. While you are at it, put some dish cleanser on a damp cloth. Squeeze the wipe to spread the soap around.
You can use warm water to clean your filter. Nonetheless, the hotter the water, the easier it is to clean.
Step 2:
Clean the gunk off the filter leaves with a soap-covered wipe. Enthusiastically scrub the two filters with the wipe. Clean both, inside and outside the cylindrical filter and make sure to wipe away any gunk that has built-up on one or the other side of it.
Then, clean the two sides of the flat, coarse filter to dispose of all the gunk on its surfaces.
Contingent upon how much gunk has built-up, you might have to involve a different wipe for each filter. Along these lines, you will not put any gunk onto the filter.
Step 3:
Place the filters straightforwardly under the faucet to wash them. This guarantees you remove each and every piece of gunk on the filters.
Ensure the water is hot and run each piece of the two filters under the stream.
You do not have to use a wipe for this step, as the water will do enough to remove the excess gunk without help from anyone else.
Step 4:
Put the coarse mesh and cylindrical filter back in the dishwasher. Slide the coarse mesh filter into place first. The filter ought to sit flush in the dishwasher.
When the coarse mesh filter is set up, put the cylindrical filter in the opening and twist it clockwise to lock it once again into the right spot.
You will hear a clicking sound when the cylindrical filter gets into place.
Well, these were two foolproof ways of cleaning your dishwasher.
Play out this errand like clockwork to keep your filter new.
Manual filters should be cleaned regularly to be at their best. Put an update in your telephone to eliminate and clean the filter once every 3 months.
Most dishwashers last close to 10 years, so the filter need not bother with being replaced all the time. In the event that you clean it regularly, it will keep going for 10 years or more.
Somebody makers propose cleaning your filter each 2-3 weeks. Take a look at the owners’ manual to see what it says.
Where is The Dishwasher Filter Located??
The dishwasher filter is located at the bottom of the dishwasher, beneath the lower spray arm.
How Often To Clean Dishwasher Filter?
It is recommended that you clean your dishwasher filter at least once a month.
Do old Dishwasher have Filters?
Yes, old dishwashers have filters. These filters help to keep the water clean and free of debris.
What is Dishwasher Self Cleaning Filter?
A dishwasher self-cleaning filter is a feature that some dishwashers have that helps to clean the dishwasher itself. The filter traps food and debris that can build up inside the dishwasher and cause it to not work properly.
We hope our guide helps you with regard to cleaning your dishwasher filter.
21 thoughts on “How To Clean Your Dishwasher Filter in 2 Easy Methods”
Comments are closed.