Electrolux Dishwasher Fault Codes & Troubleshooting
| Fault Code | Meaning | DIY Fix | Possible Parts |
|---|---|---|---|
| Water & Leak Issues | |||
| i10 | Not enough water entering the dishwasher | • Ensure water supply is turned on • Check inlet hose for kinks/blockages • Clean water inlet filter | Water inlet valve |
| i20 | Dishwasher not draining properly | • Check drain hose for clogs/kinks • Clean dishwasher filter and drain pump | Drain hose, filter, drain pump |
| i30 | Water leakage detected in base | • Check hoses for leaks • Dry dishwasher base • Ensure dishwasher is level | Seals, hoses |
| Fr-01 | Sensor detected water leak | • Shut off power • Inspect hoses, pumps, tub for leaks • Replace leaking parts | Drain hose, drain pump, recirculation pump |
| Sensor & Heating Issues | |||
| i60 | Water not heating properly | • Check water heater element • Ensure temperature sensor is functioning | Heating element, temperature sensor |
| i70 | Temperature sensor malfunction | • Check sensor wiring connections • Replace sensor if faulty | Temperature sensor |
| Fr-02 | Thermistor/turbidity sensor failure | • Check sensor connections • Replace thermistor if faulty | Thermistor |
| Motor & Pump Issues | |||
| i50 | Drain or circulation pump failure | • Reset dishwasher • Replace if pump makes strange noises | Drain pump, circulation pump |
| Fr-03 | Wash motor failure | • Check wiring connections • Replace wash motor if needed | Wash motor |
| Fr-07/Fr-11 | Drain valve failure | • Inspect drain valve for blockages • Replace if defective | Drain valve |
| Fr-12 | Drain valve position fault | • Reset dishwasher • Check if drain valve is obstructed/broken | Drain valve |
| Fan & Vent Issues | |||
| Fr-04/Fr-05 | Upper fan/vent failure | • Inspect fan for blockages • Replace fan if necessary | Upper ventilation fan |
| Fr-06 | Lower fan failure | • Check fan wiring • Replace fan if needed | Lower ventilation fan |
| Control & Communication Faults | |||
| i80 | Control board communication failure | • Reset dishwasher • Replace control board if issue persists | Main control board |
| Fr-08 | User interface control failure | • Reset dishwasher • Replace user interface control | User interface control |
| Fr-09 | Communication failure between UI and control board | • Check wiring between control board and UI • Reset dishwasher • Replace faulty control board | Control board, UI wiring |
| Fr-10 | Electronic control board relay failure | • Reset dishwasher • Replace control board if problem persists | Control board |
| Fr-13 | Electronic control board failure | • Reset dishwasher • Replace control board if problem persists | Main control board |
General Troubleshooting Steps
- Reset the Dishwasher: Unplug for 10-15 minutes and restart
- Check Filters & Hoses: Clean clogs in water inlet/drain system
- Inspect Wiring & Connections: Ensure no loose/damaged wires
- Call a Technician: If fault persists, seek professional service
Click to rate this post!
[Total: 1 Average: 5]
