Hoover Dishwasher Fault Codes and Solutions
| Fault Code | Description | Cause | Solution |
|---|---|---|---|
| E01 | Water Inlet Fault | Dishwasher isn’t filling | Ensure the water supply is active, and inspect the inlet valve and hose for issues. |
| E02 | Drainage Fault | Water isn’t draining | Examine the filter, drain hose, and pump to clear any blockages. |
| E03 | Heating Fault | Water isn’t heating | Inspect the heating element and thermostat to confirm proper operation. |
| E04 | Overflow/Leakage | Too much water or a leak detected | Review the water level sensor, inlet valve, and hose connections for leaks. |
| E05 | Motor Fault | Issue with wash motor | Assess the motor’s condition and replace if it shows signs of failure. |
| E06 | Pressure Switch Fault | Water level detection issue | Check the pressure switch for proper functionality and replace if needed. |
| E07 | Turbidity Sensor Fault | Water clarity sensor issue | Clean the turbidity sensor thoroughly or install a new one if faulty. |
| E08 | Diverter Valve Fault | Water not reaching spray arms | Inspect the diverter valve for blockages and replace if necessary. |
| E09 | Water Softener Fault | Water softener not functioning | Verify salt levels and clean the regeneration valve for optimal performance. |
| E10 | Circulation Pump Fault | Pump not operating properly | Test the circulation pump and remove any debris that may be obstructing it. |
| E11 | Drying System Fault | Dishwasher isn’t drying properly | Examine the drying fan, heating element, and ventilation system for issues. |
| F1 | Water Inlet Problem | Dishwasher isn’t filling | Ensure water supply is active and the inlet valve is clear of debris. |
| F2 | Drainage Problem | Dishwasher is not draining | Inspect and clean the drain hose, pump, and filter to ensure proper flow. |
| F3 | Heating Problem | Dishwasher isn’t heating | Evaluate the heating element and thermostat for faults and replace if defective. |
| F4 | Overflow or Leak Detection | Excess water detected | Inspect the float switch, sensors, and hoses for any signs of leaks or damage. |
| F5 | Motor Fault | Wash motor not functioning | Conduct a thorough check of the motor and replace it if found faulty. |
| F6 | Pressure Switch Problem | Water level sensor issue | Clean the pressure switch thoroughly or replace if malfunctioning. |
| F7 | Turbidity Sensor Problem | Water clarity sensor malfunction | Ensure the turbidity sensor is clean and operational, replacing if needed. |
| F8 | Diverter Valve Problem | Water flow not reaching spray arms | Clear any obstructions and replace the diverter valve if it is defective. |
| F9 | Water Softener Problem | Softener system not working | Confirm adequate salt levels and clean the regeneration valve for efficiency. |
Click to rate this post!
[Total: 0 Average: 0]
